Introduction Osborne A335 is a single-component high-intensity ultraviolet light curing adhesive, low surface a variety of metals such as stainless steel, aluminum and plating surface, special glass and other inorganic materials can have a very high adhesion; continued after curing impact percussion aluminum or stainless steel sheet, make the whole sheet bending deformation, high frequency vibration resistant; UV glue obvious than greater transparency, long-term product after curing the same yellow, not albino; ??low temperature, Excellent performance of high temperature and humidity. Typical uses are widely used in glass furniture, glass coffee table, glass dining table, glass handicrafts, watches, lighting, and other manufacturing industries. ? Before and after curing technology parameters A335 test items outside ?? degree view of transparent liquid viscosity ?? ?????? mpa.s 1500 Density 25 ℃ ???? g / cm3 1.08 degrees ???? ???? hard Shao D 70 ± 5 Tensile strength ???? MPa 80% elongation at break ??? glass transition temperature of 120 ?? Tg ℃ 65 shear strength glass / aluminum MPa ≥20 temperature range ??? ℃ -40 ~ 150 Note: Curing performance indicators 1000W lamp curing 5min testing. Positioning and curing? Lamp intensity (W) (medium pressure mercury lamp) 1000? Positioning time (S) 5 ~ 10? Curing time (S) 30 ~ 60 Instructions 1. Glue the site should be cleared of oil and dry. 2. Place the glue has been pushed to clean the surface of the substrate, so that distribution can be. Close two planes, with a wavelength of 365nm is irradiated with UV light, ultraviolet light can confirm shone through to the bonding site, the curing time is 5-6 times the same ultraviolet light intensity at a fixed time to ensure complete curing adhesive. 3. The curing speed depends on the distance of the product of the intensity of the ultraviolet light source and the subbing layer, depth of cure needed or bondline gap, and the light transmittance of the substrate and the like. 4. unused plastic cap should be tightened immediately, kept under seal. This product is UV sensitive. During storage and handling should be avoided exposure to sunlight, UV light and artificial light sources. This product applications are dispensed from black feed tube. 5. To make the surface exposed to air, the full cure, a relatively high intensity UV smallest 100mW / cm2 or UV irradiation wavelength of 250nm. Notes 1. away from children. 2. Do not have poured glue and then back into the original packaging to avoid contamination of the glue. After contact with skin; 3. This product contains methyl acrylate and monomer, a slight skin and eye irritation, if accidentally splashed into the eyes, rinse immediately with plenty of water, as there does not need to go to hospital Please wash immediately with soap and plenty of water. Packing 250 g / bottle. 1. The product storage and transportation needs at below 25 ℃ storage in a cool dry environment, avoid ultraviolet light or sunlight, otherwise it will undergo polymerization, the storage period of 12 months. 2. This product is non-dangerous goods, according to general chemical transport, be careful leakage during transportation!